Products

  • uBLOX MAX-M8Q GPS Breakout for Active Antennas

    0 out of 5

    This is an assembled breakout board with a uBLOX MAX-M8Q-10 module and SMA female connector suitable for connecting to a suitable active patch antenna (See related products).

    Suitable for HAB Usage Max Altitude 50,000 meters / 164041 feet in Flight Mode.

    The board is constructed on 1.6mm PCB and features a PPS LED and Supercap for retaining settings through power cycles. Improved power filtering over previous versions.

    On the header are TX, RX, TP (PPS Output), 3V Supply (2.7V to 3.6V), I2C SDA/SCL and GND.

    The MAX-M8Q delivers all the benefits of the u-blox 8 GPS platform in a more compact form factor than ever before: high-sensitivity, intelligent power management.

    Supporting temperatures down to -40’C and featuring a TCXO for better power saving and quicker startup the MAX M8Q is an ideal module.

    As per the data sheets the MAX M8Q can use upto 22mA under aquisition (5mA in power save mode once tracking).

    The breakout has the following dimensions : 22mmx22mmx1.6mm approximately.

    The default baud rate is 9600bps.

    $33.95
  • UHF to BNC Adapter

    0 out of 5
    • Adapts a BNC Female to accept a UHF male connector (PL259).

    While UHF connectors are not our favorite at higher frequencies, we also know there are some who will want UHF adapters, so we will sell these for those who want them (see note below *). These will also work fine for the Spyverter.

    * Due to the wideband nature of the SDR units, use of UHF connectors is highly discouraged if you intend to use the unit above 500 MHz. Why? UHF connectors act like a brick wall to RF signals at higher frequencies, and we want you to get the most out of your SDR receiver.

    $6.95
  • UHF to SMA Adapter – GOLD & NICKEL

    0 out of 5
    • Adapts the unit to accept a UHF male connector (PL259).

    While UHF connectors are not our favorite at higher frequencies, we also know there are some who will want UHF adapters, so we will sell these for those who want them (see note below *). These will also work fine for the Spyverter.

    * Due to the wideband nature of the SDR units, use of UHF connectors is highly discouraged if you intend to use the unit above 500 MHz. Why? UHF connectors act like a brick wall to RF signals at higher frequencies, and we want you to get the most out of your SDR receiver.

    $6.95
  • USB Cable for Filter/Preamps

    0 out of 5
    • USB cable for the Filter/Preamps and Preamps.
    • Use as a replacement or spare cable.
    • For use when Bias-T is not available (when Airspy is not used)
    • NOTE: NOT compatible with Airspy (use OEM cable)
    $2.45
  • Wideband 0.1-4 GHz Preamp

    0 out of 5
    • Wideband Preamp for general use.
    • Fully compatible with Airspy.
    • 100% compatible with the Airspy bias-t. (no external power required)
    • Approximately 20dB gain.
    • Low 0.75dB noise figure (NF).
    • Manufacturer’s website
    • Note: This item was custom made just for Airspy.US.
    $45.95